GNU Info

(emacs)Case

---

Next: Text Mode Prev: Filling Up: Text

---

Enter node , (file) or (file)node

Case Conversion Commands
========================

   Emacs has commands for converting either a single word or any
arbitrary range of text to upper case or to lower case.

`M-l'
     Convert following word to lower case (`downcase-word').

`M-u'
     Convert following word to upper case (`upcase-word').

`M-c'
     Capitalize the following word (`capitalize-word').

`C-x C-l'
     Convert region to lower case (`downcase-region').

`C-x C-u'
     Convert region to upper case (`upcase-region').

   The word conversion commands are the most useful.  `M-l'
(`downcase-word') converts the word after point to lower case, moving
past it.  Thus, repeating `M-l' converts successive words.  `M-u'
(`upcase-word') converts to all capitals instead, while `M-c'
(`capitalize-word') puts the first letter of the word into upper case
and the rest into lower case.  All these commands convert several words
at once if given an argument.  They are especially convenient for
converting a large amount of text from all upper case to mixed case,
because you can move through the text using `M-l', `M-u' or `M-c' on
each word as appropriate, occasionally using `M-f' instead to skip a
word.

   When given a negative argument, the word case conversion commands
apply to the appropriate number of words before point, but do not move
point.  This is convenient when you have just typed a word in the wrong
case: you can give the case conversion command and continue typing.

   If a word case conversion command is given in the middle of a word,
it applies only to the part of the word which follows point.  This is
just like what `M-d' (`kill-word') does.  With a negative argument,
case conversion applies only to the part of the word before point.

   The other case conversion commands are `C-x C-u' (`upcase-region')
and `C-x C-l' (`downcase-region'), which convert everything between
point and mark to the specified case.  Point and mark do not move.

   The region case conversion commands `upcase-region' and
`downcase-region' are normally disabled.  This means that they ask for
confirmation if you try to use them.  When you confirm, you may enable
the command, which means it will not ask for confirmation again.  Note:
Disabling.