AL1700-DIAG

Section: Maintenance Commands (8)
Updated: February 23, 2001
Index
Return to Main Contents

NAME

al1700-diag - Diagnostic program for the Allied Telesis AT1700

SYNOPSIS

al1700-diag [options]

DESCRIPTION

al1700-diag is a diagnostic program for the Allied Telesis AT1700, and similar boards built around the Fujitsu MB86965. It does not test every possible hardware fault, but it does verify the basic functionality ofthe board.

OPTIONS

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.

-h, --help: Show summary of options.
-V, --version: Show version of program.
-v, --verbose: Verbose mode.
-q, --quiet: Be very unverbose.
-a, --all: Print all registers.
-e, --show-eeprom: Dump EEPROM contents to stdout.
-p, --base-address <port>: Specify port to use.
-F, --new-interface <interface>: Interface number. Options that make sense are: 10baseT, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.
-P <address>: Set card to a new IO base address.
-Q <irq>: Set card to a new IRQ.
-m, --show-mii: Dump MII management registers.
-r, --reset-ASIC: Reset the ASIC.
-m: Tests multicast.
-w, --write-EEPROM <values>: Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!

AUTHOR

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).

This document was created by man2html, using the manual pages.
Time: 14:30:55 GMT, April 25, 2024