SCP

Section: User Commands (1)
Index
Return to Main Contents

BSD mandoc

NAME

scp - secure copy (remote file copy program)

SYNOPSIS

scp [-pqrvBC1246 ] [-F ssh_config ] [-S program ] [-P port ] [-c cipher ] [-i identity_file ] [-o ssh_option ] Sm off [[user@ ] host1 : file1 ] Sm on [... ] Sm off [[user@ ] host2 : file2 ] Sm on

DESCRIPTION

scp copies files between hosts on a network. It uses ssh(1) for data transfer, and uses the same authentication and provides the same security as ssh(1). Unlike rcp(1), scp will ask for passwords or passphrases if they are needed for authentication.

Any file name may contain a host and user specification to indicate that the file is to be copied to/from that host. Copies between two remote hosts are permitted.

The options are as follows:

-c cipher: Selects the cipher to use for encrypting the data transfer. This option is directly passed to ssh(1).
-i identity_file: Selects the file from which the identity (private key) for RSA authentication is read. This option is directly passed to ssh(1).
-p: Preserves modification times, access times, and modes from the original file.
-r: Recursively copy entire directories.
-v: Verbose mode. Causes scp and ssh(1) to print debugging messages about their progress. This is helpful in debugging connection, authentication, and configuration problems.
-B: Selects batch mode (prevents asking for passwords or passphrases).
-q: Disables the progress meter.
-C: Compression enable. Passes the -C flag to ssh(1) to enable compression.
-F ssh_config: Specifies an alternative per-user configuration file for ssh This option is directly passed to ssh(1).
-P port: Specifies the port to connect to on the remote host. Note that this option is written with a capital `P' because -p is already reserved for preserving the times and modes of the file in rcp(1).
-S program: Name of program to use for the encrypted connection. The program must understand ssh(1) options.
-o ssh_option: Can be used to pass options to ssh in the format used in ssh_config5. This is useful for specifying options for which there is no separate scp command-line flag. For example, forcing the use of protocol version 1 is specified using scp -oProtocol=1
-1: Forces scp to try protocol version 1 only.
-2: Forces scp to try protocol version 2 only.
-4: Forces scp to use IPv4 addresses only.
-6: Forces scp to use IPv6 addresses only.

DIAGNOSTICS

scp exits with 0 on success or >0 if an error occurred.

AUTHORS

Timo Rinne <tri@iki.fi> and Tatu Ylonen <ylo@cs.hut.fi>

HISTORY

scp is based on the rcp(1) program in BSD source code from the Regents of the University of California.

This document was created by man2html, using the manual pages.
Time: 23:52:41 GMT, April 19, 2024

SCP