# Some of the items will probably need adjustments to
# meet local needs.
#
# replace the snmp read community string below as needed

target --default--
    short-desc  =   "%swname%:  %interface-desc%"
    long-desc   =   %interface-desc%
    util-dir    =   /usr/share/cricket/util
    inst        =   %InterfaceID%
    snmp-community  =   public
    snmp-host   =   %swname%

# Note that the following OIDs are sampling cells and
# not bits/bytes.  For all rrd-max entries in the interface
# target definitions, you need to adjust to make sure you
# are using cell counts.  For the Cascade Switches used here,
# defining rrd-max values is imperative because these devices
# send out bogus cell counter readings about once per week that
# will mess up graphs if you don't cap them off.
#
# Cell counts are actually a nice fit here - with a full OC-3 pipe,
# you can churn the counters in way less than 5 minutes, so this
# gives headroom with a more reasonable sampling interval.

oid pportInCells    1.3.6.1.4.1.277.1.4.2.1.43
oid pportOutCells   1.3.6.1.4.1.277.1.4.2.1.45
oid cktAtmInCells   1.3.6.1.4.1.277.1.6.1.1.88
oid cktAtmOutCells  1.3.6.1.4.1.277.1.6.1.1.89

# graph defaults for all ATM stats
# always convert ATM cells to bits for graphing (53 * 8 = 424)

graph   --default--
    scale       =  424,*
    bytes       =  true
    y-axis      =  "bits per second"
    units       =  "bits/sec"