Kernel driver `i2c-sis5595.o' Status: Beta Supported adapters: * Silicon Integrated Systems Corp. SiS5595 Southbridge Datasheet: Publicly available at the Silicon Integrated Systems Corp. site. Author: Frodo Looijaard and Mark D. Studebaker Note: all have mfr. ID 0x1039. SUPPORTED PCI ID 5595 0008 Note: The chips below contain a 0008 device which is incompatible with the 5595. We recognize these by the presence of the listed "blacklist" PCI ID and refuse to load. NOT SUPPORTED PCI ID BLACKLIST PCI ID 540 0008 0540 550 0008 0550 5513 0008 5511 5581 0008 5597 5582 0008 5597 5597 0008 5597 5598 0008 5597/5598 630 0008 0630 645 0008 0645 730 0008 0730 735 0008 0735 Module Parameters ----------------- force_addr=0xaddr Set the I/O base address. Useful for boards that don't set the address in the BIOS. Does not do a PCI force; the device must still be present in lspci. Don't use this unless the driver complains that the base address is not set. Example: 'modprobe i2c-sis5595 force_addr=0x290' Description ----------- i2c-sis5595 is a true SMBus host driver for motherboards with the SiS5595 southbridges. WARNING: If you are trying to access the integrated sensors on the SiS5595 chip, you want the sis5595.o driver for those, not this driver. This driver is a BUS driver, not a CHIP driver. A BUS driver is used by other CHIP drivers to access chips on the bus. To install this driver, simply do # modprobe i2c-sis5595 This driver is ALPHA!!! Please send feedback to us at sensors@stimpy.netroedge.com.