Kernel driver `i2c-voodoo3.o' Status: 'Beta' and still under development and testing Supported adapters: * 3dfx Voodoo3 based cards * Voodoo Banshee based cards Author: Frodo Looijaard , Philip Edelbrock , Ralph Metzler , and Mark D. Studebaker Main contact: Philip Edelbrock The code is based upon Ralph's test code (he did the hard stuff ;') Module Parameters ----------------- (none) Description ----------- The 3dfx Voodoo3 chip contains two I2C interfaces (aka a I2C 'master' or 'host'). The first interface is used for DDC (Data Display Channel) which is a serial channel through the VGA monitor connector to a DDC-compliant monitor. This interface is defined by the Video Electronics Standards Association (VESA). The standards are available for purchase at http://www.vesa.org . The second interface is a general-purpose I2C bus. The intent by 3dfx was to allow manufacturers to add extra chips to the video card such as a TV-out chip such as the BT869 or possibly even I2C based temperature sensors like the ADM1021 or LM75. The 'feature' set of this driver is based on the i2c-piix4 (SMBus) features. I.e., SMBus byte reads and writes, as well as detected faults in transmission. Quick reads/writes, block transactions, word transactions, are yet unwritten but are probably not too hard to add. Stability --------- Seems to be stable on the test machine, but needs more testing on other machines. Simultaneous accesses of the DDC and I2C busses may cause errors. Supported Devices ----------------- Specifically, this driver was written and tested on the '3dfx Voodoo3 AGP 3000' which has a tv-out feature (s-video or composite). According to the docs and discussions, this code should work for any Voodoo3 based cards as well as Voodoo Banshee based cards. The DDC interface has been tested on a Voodoo Banshee card. Features -------- This driver controls the I2C controller of the Voodoo3 chip. 'byte read' transactions and 'data_byte write' transactions are supported, but all else is not (but is probably easy to add if the need arises). Issues ------ Probably many, but it seems to work OK on my system. :') External Device Connection -------------------------- The digital video input jumpers give availability to the I2C bus. Specifically, pins 13 and 25 (bottom row middle, and bottom right-end) are the I2C clock and I2C data lines, respectively. +5V and GND are probably also easily available making the addition of extra I2C/SMBus devices easy to implement.