GNU Info

(gcc-300.info)Gcov and Optimization

---

Next: Gcov Data Files Prev: Invoking Gcov Up: Gcov

---

Enter node , (file) or (file)node

Using `gcov' with GCC Optimization
==================================

   If you plan to use `gcov' to help optimize your code, you must first
compile your program with two special GCC options: `-fprofile-arcs
-ftest-coverage'.  Aside from that, you can use any other GCC options;
but if you want to prove that every single line in your program was
executed, you should not compile with optimization at the same time.
On some machines the optimizer can eliminate some simple code lines by
combining them with other lines.  For example, code like this:

     if (a != b)
       c = 1;
     else
       c = 0;

can be compiled into one instruction on some machines.  In this case,
there is no way for `gcov' to calculate separate execution counts for
each line because there isn't separate code for each line.  Hence the
`gcov' output looks like this if you compiled the program with
optimization:

           100  if (a != b)
           100    c = 1;
           100  else
           100    c = 0;

   The output shows that this block of code, combined by optimization,
executed 100 times.  In one sense this result is correct, because there
was only one instruction representing all four of these lines.  However,
the output does not indicate how many times the result was 0 and how
many times the result was 1.