Using the E7000 in-circuit emulator
...................................
You can use the E7000 in-circuit emulator to develop code for either
the Hitachi SH or the H8/300H. Use one of these forms of the `target
e7000' command to connect GDB to your E7000:
`target e7000 PORT SPEED'
Use this form if your E7000 is connected to a serial port. The
PORT argument identifies what serial port to use (for example,
`com2'). The third argument is the line speed in bits per second
(for example, `9600').
`target e7000 HOSTNAME'
If your E7000 is installed as a host on a TCP/IP network, you can
just specify its hostname; GDB uses `telnet' to connect.