GNU Info

(gdb.info)Starting

---

Next: Arguments Prev: Compilation Up: Running

---

Enter node , (file) or (file)node

Starting your program
=====================

`run'
`r'
     Use the `run' command to start your program under GDB.  You must
     first specify the program name (except on VxWorks) with an
     argument to GDB (Note: Getting In and Out of GDB.), or
     by using the `file' or `exec-file' command (Note: Commands to
     specify files.).

   If you are running your program in an execution environment that
supports processes, `run' creates an inferior process and makes that
process run your program.  (In environments without processes, `run'
jumps to the start of your program.)

   The execution of a program is affected by certain information it
receives from its superior.  GDB provides ways to specify this
information, which you must do _before_ starting your program.  (You
can change it after starting your program, but such changes only affect
your program the next time you start it.)  This information may be
divided into four categories:

The _arguments._
     Specify the arguments to give your program as the arguments of the
     `run' command.  If a shell is available on your target, the shell
     is used to pass the arguments, so that you may use normal
     conventions (such as wildcard expansion or variable substitution)
     in describing the arguments.  In Unix systems, you can control
     which shell is used with the `SHELL' environment variable.  Note:
     Your program's arguments.

The _environment._
     Your program normally inherits its environment from GDB, but you
     can use the GDB commands `set environment' and `unset environment'
     to change parts of the environment that affect your program.
     Note: Your program's environment.

The _working directory._
     Your program inherits its working directory from GDB.  You can set
     the GDB working directory with the `cd' command in GDB.  Note:
     Your program's working directory.

The _standard input and output._
     Your program normally uses the same device for standard input and
     standard output as GDB is using.  You can redirect input and output
     in the `run' command line, or you can use the `tty' command to set
     a different device for your program.  Note: Your program's input
     and output.

     _Warning:_ While input and output redirection work, you cannot use
     pipes to pass the output of the program you are debugging to
     another program; if you attempt this, GDB is likely to wind up
     debugging the wrong program.

   When you issue the `run' command, your program begins to execute
immediately.  Note: Stopping and continuing, for discussion
of how to arrange for your program to stop.  Once your program has
stopped, you may call functions in your program, using the `print' or
`call' commands.  Note: Examining Data.

   If the modification time of your symbol file has changed since the
last time GDB read its symbols, GDB discards its symbol table, and
reads it again.  When it does this, GDB tries to retain your current
breakpoints.