GNU Info

(make.info)Sequences

---

Next: Empty Commands Prev: Recursion Up: Commands

---

Enter node , (file) or (file)node

Defining Canned Command Sequences
=================================

   When the same sequence of commands is useful in making various
targets, you can define it as a canned sequence with the `define'
directive, and refer to the canned sequence from the rules for those
targets.  The canned sequence is actually a variable, so the name must
not conflict with other variable names.

   Here is an example of defining a canned sequence of commands:

     define run-yacc
     yacc $(firstword $^)
     mv y.tab.c $@
     endef

Here `run-yacc' is the name of the variable being defined; `endef'
marks the end of the definition; the lines in between are the commands.
The `define' directive does not expand variable references and
function calls in the canned sequence; the `$' characters, parentheses,
variable names, and so on, all become part of the value of the variable
you are defining.  Note: Defining Variables Verbatim, for a
complete explanation of `define'.

   The first command in this example runs Yacc on the first
prerequisite of whichever rule uses the canned sequence.  The output
file from Yacc is always named `y.tab.c'.  The second command moves the
output to the rule's target file name.

   To use the canned sequence, substitute the variable into the
commands of a rule.  You can substitute it like any other variable
(Note: Basics of Variable References.).  Because variables
defined by `define' are recursively expanded variables, all the
variable references you wrote inside the `define' are expanded now.
For example:

     foo.c : foo.y
             $(run-yacc)

`foo.y' will be substituted for the variable `$^' when it occurs in
`run-yacc''s value, and `foo.c' for `$@'.

   This is a realistic example, but this particular one is not needed in
practice because `make' has an implicit rule to figure out these
commands based on the file names involved (*note Using Implicit Rules:
Implicit Rules.).

   In command execution, each line of a canned sequence is treated just
as if the line appeared on its own in the rule, preceded by a tab.  In
particular, `make' invokes a separate subshell for each line.  You can
use the special prefix characters that affect command lines (`@', `-',
and `+') on each line of a canned sequence.  Note: Writing the Commands
in Rules.  For example, using this canned sequence:

     define frobnicate
     @echo "frobnicating target $@"
     frob-step-1 $< -o $@-step-1
     frob-step-2 $@-step-1 -o $@
     endef

`make' will not echo the first line, the `echo' command.  But it _will_
echo the following two command lines.

   On the other hand, prefix characters on the command line that refers
to a canned sequence apply to every line in the sequence.  So the rule:

     frob.out: frob.in
             @$(frobnicate)

does not echo _any_ commands.  (Note: Command Echoing, for a
full explanation of `@'.)