Copyright (C) 2000-2012 |
Whole document tree 8. The Sound Drivers
With the sound driver(s) compiled into older kernels,
it was virtually impossible to change the parameters that
were selected at compile time. Now, each driver has an
individual boot argument, and no defaults are set at
compile time (i.e. you must supply a boot
argument for older non-PNP ISA cards to be detected.)
If information on your card is not here then check the files
in
8.1 The AD1848 (`ad1848=')This takes an argument of the form:
8.2 The Adlib (`adlib=')This takes an argument of the form:
8.3 The MAD16 (`mad16=')This takes an argument of the form:
8.4 The ProAudioSpectrum PAS16 (`pas2=')This takes an argument of the form:
where the
8.5 The SoundBlaster (`sb=')This takes an argument of the form:
8.6 The UART 401 (`uart401=')This takes an argument of the form:
8.7 The UART 6850 (`uart6850=')This takes an argument of the form:
8.8 The Yamaha OPL2/OPL3/OPL4 FM Synthesizer (`opl3=')This argument expects an I/O address only, and the most
common one (for ISA cards) is
8.9 The Yamaha OPL3-SA FM Synthesizer (`opl3sa=')This takes an argument of the form:
8.10 The Yamaha OPL3-SA2/SA3 FM Synthesizer (`opl3sa2=')This takes an argument of the form:
Next Previous Contents |