If you haven't installed your network card and adapter driver, do so now.
Descriptions to perform this task is beyond the scope of this document.
Install the TCP/IP 32b package if you haven't already.
In 'Main'/'Windows Setup'/'Network Setup',
click on 'Drivers'.
Highlight 'Microsoft TCP/IP-32 3.11b' in
the 'Network Drivers' section, click
'Setup'.
Set the IP Address to 192.168.0.x (1 < x < 255), then set the Subnet
Mask to 255.255.255.0 and Default Gateway to 192.168.0.1
Do not enable any of the following options (unless you know what you are
doing):
Click 'DNS', fill in the appropriate
information your Linux host uses (usually found in /etc/resolv.conf). Then
click 'OK' when you're done with it.
Click 'Advanced', check
'Enable DNS for Windows Name Resolution'
and 'Enable LMHOSTS lookup' found in
c:\windows.
Click 'OK' in all dialog boxes and restart
the system.
As an initial test, ping the linux box to test the network
connection: 'File/Run', type: ping
192.168.0.1 (This is only an INTERNAL LAN connection test so you might
not be able to ping the outside world yet.) If you don't
see "replies" to your PINGs, please verify your network configuration.