Whole document tree
    

Whole document tree

Configure PCMCIA Support


Configure PCMCIA Support

There is an alternate step, before the ``Configure Device Driver Modules'' menu selection, called ``Configure PCMCIA Support.'' This menu is used to enable PCMCIA support.

If you do have PCMCIA but are not installing your Debian system using it (i.e., installation with a PCMCIA Ethernet card), you need not configure PCMCIA at this point. You can easily configure and enable PCMCIA at a later point, after installation is complete. However, if you are installing by way of a PCMCIA network device, this alternate must be selected, and PCMCIA support must be configured prior to configuring the network.

If you need to install PCMCIA, select the alternate below ``Configure Device Driver Modules.'' You will be asked which PCMCIA controller your system contains. In most cases, this will be i82365. In some cases, it will be tcic; your laptop's vendor-supplied specifications should provide the information. You can generally leave the next few sets of options blank. Again, certain hardware has special needs; the Linux PCMCIA HOWTO contains plenty of information in case the default doesn't work.

In some unusual cases, you may also need to modify the file /etc/pcmcia/config.opts. You can open your second virtual terminal (Left Alt-F2) and edit the file there and then reconfigure your PCMCIA, or you can manually force a reload of the modules using insmod and rmmod.

Once PCMCIA is properly configured and installed, you should configure your device drivers as described in the next section.

John Goerzen / Ossama Othman