GNU Info

Info Node: (texinfo)Headings Introduced

(texinfo)Headings Introduced


Next: Heading Format Prev: Headings Up: Headings
Enter node , (file) or (file)node

Headings Introduced
===================

  Texinfo provides standard page heading formats for manuals that are
printed on one side of each sheet of paper and for manuals that are
printed on both sides of the paper.  Typically, you will use these
formats, but you can specify your own format if you wish.

  In addition, you can specify whether chapters should begin on a new
page, or merely continue the same page as the previous chapter; and if
chapters begin on new pages, you can specify whether they must be
odd-numbered pages.

  By convention, a book is printed on both sides of each sheet of paper.
When you open a book, the right-hand page is odd-numbered, and chapters
begin on right-hand pages--a preceding left-hand page is left blank if
necessary.  Reports, however, are often printed on just one side of
paper, and chapters begin on a fresh page immediately following the end
of the preceding chapter.  In short or informal reports, chapters often
do not begin on a new page at all, but are separated from the preceding
text by a small amount of whitespace.

  The `@setchapternewpage' command controls whether chapters begin on
new pages, and whether one of the standard heading formats is used.  In
addition, Texinfo has several heading and footing commands that you can
use to generate your own heading and footing formats.

  In Texinfo, headings and footings are single lines at the tops and
bottoms of pages; you cannot create multiline headings or footings.
Each header or footer line is divided into three parts: a left part, a
middle part, and a right part.  Any part, or a whole line, may be left
blank.  Text for the left part of a header or footer line is set
flushleft; text for the middle part is centered; and, text for the
right part is set flushright.


automatically generated by info2www version 1.2.2.9