Whole document tree

8.8.7 Handling of Jump Instructions

Jump instructions are always optimized to use the smallest possible displacements. This is accomplished by using byte (8-bit) displacement jumps whenever the target is sufficiently close. If a byte displacement is insufficient a long (32-bit) displacement is used. We do not support word (16-bit) displacement jumps (i.e. prefixing the jump instruction with the `addr16' opcode prefix), since the 80386 insists upon masking `%eip' to 16 bits after the word displacement is added.

Note that the `jcxz', `jecxz', `loop', `loopz', `loope', `loopnz' and `loopne' instructions only come in byte displacements, so that if you use these instructions (gcc does not use them) you may get an error message (and incorrect code). The AT&T 80386 assembler tries to get around this problem by expanding `jcxz foo' to

jcxz cx_zero jmp cx_nonzero cx_zero: jmp foo cx_nonzero: