Whole document tree
| [ < ] | [ > ] | [ << ] | [ Up ] | [ >> ] | [Top] | [Contents] | [Index] | [ ? ] |
8.4.2.3 Special Characters
`;' and `#' are the line comment characters. Sub-instructions may be executed in order, in reverse-order, or in parallel. Instructions listed in the standard one-per-line format will be executed sequentially. To specify the executing order, use the following symbols:- `->'
- Sequential with instruction on the left first.
- `<-'
- Sequential with instruction on the right first.
- `||'
- Parallel
abs a1 -> abs r0- Execute these sequentially. The instruction on the right is in the right container and is executed second.
abs r0 <- abs a1- Execute these reverse-sequentially. The instruction on the right is in the right container, and is executed first.
ld2w r2,@r8+ || mac a0,r0,r7- Execute these in parallel.
ld2w r2,@r8+ ||mac a0,r0,r7- Two-line format. Execute these in parallel.
ld2w r2,@r8+mac a0,r0,r7- Two-line format. Execute these sequentially. Assembler will put them in the proper containers.
ld2w r2,@r8+ ->mac a0,r0,r7- Two-line format. Execute these sequentially. Same as above but second instruction will always go into right container.
This document was generated by root on January, 30 2002 using texi2html